Eaton IQ 150S, User & Installation Manual

Page: 125 / 234

IM02601006E www.eaton.com 6-9
IQ 150S/250S 6: Ethernet Configuration
4. Press
Enter
again, quickly.
5. After entering Setup Mode (confirm by pressing Enter), you can configure the parameters for the
software you are using by entering one of the numbers on the Change Setup Menu, or you can
confirm default values by pressing
Enter
. Be sure to store new configurations when you are fin-
ished. The Ethernet Interface will then perform a power reset and the Factory Default Settings
will display again (refer to Section 6.2.1).
6.3.4: Setup Details
This section illustrates how each section of settings appears on the screen, if you press Y (Yes) to
change one or more of the settings.
CAUTION!
Change Settings 1 and 6 ONLY. Settings 2, 3, and 4 must be the same as shown in
Section 6.2.1. If they are not, reset them to the values shown in Section 6.2.1.
Network IP Settings Detail (1) (Set device with static IP Address.)
Network Mode: 0=Wired only, 1=Wireless Only <0> ? 1
IP Address <010> 192.<000> 168.<000> .<000> .<001>
Set Gateway IP Address <N> ? Y
Gateway IP Address : <192> .<168> .<000> .<001>
Set Netmask <N for default> <Y> ? Y
<255> .<255> .<255> .<000>
Change telnet config password <N> ? N
Serial & Mode Settings (2) (Make sure these settings match those shown in Section 6.2.1.)
Attached Device (1=Slave 2=Master) (1) ? 1
Serial Protocol (1=Modbus/RTU 2=Modbus/ASCII) (1) ? 1
Serial Number 5415404 MAC Address 00:20:4A:54:3C:2C
Software Version V01.2 (000719)
Press Enter to go into Setup Mode