i-on40 & i-onEX Range
Page 15
2. Alarms
The table below shows the different kinds of alarms possible.
Type of
Alarm
Signal
Started by:
Intruder
Loud warbling tone
from siren.
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire
Pulsing tone from
sirens, internal
sounders and wired
keypads.
Fire zone activated at any time.
Hold Up
Loud warbling tone
from siren
HUA zone or radio Hold Up Alarm
transmitter activated at any time.
Pressed on keypad.
(The installer must enable this feature
on your system.)
Tamper
Loud warbling tone
from siren
Some part of the alarm system has
been opened (tampered with).
An alarm system cable has been cut
or shorted.
An incorrect user code has been
entered too many times.
Technical
Quiet beeping once
per second from
wired keypads.
Technical alarm zone activated at any
time.
(Audible only when system is unset.)
Fault
Quiet beeping once
per second from
wired keypads.
A system fault detected by the control
unit, for example, mains failure, or
communications line fault. See page
19.
