User Menu Options
Page 58
Set, Partitions
(partitioned system)
– Full sets or part
sets selected partitions that the user belongs to. After
selecting this option, use
or
to scroll through the
partitions and use
or
to select No (do not set
partition), Full (full set the partition) or PartB/C/D (part
set the partition). Press
when you have finished.
Set, Full Set All
(partitioned system)
– Full sets all
partitions that the user belongs to.
Set, Full Set
(part-setting system)
– Full sets the whole
system.
Set, Part Set B\C\D
(part-setting system)
– Sets part
set B, C or D.
Note:
If you choose Unset, ask your installer whether the
entry timer needs to be running before a user can unset
using a remote control.
Output
To operate a user-defined output. Use
or
followed by
to select the output, then use
or
followed by
to
select the output mode:
On
– Switches the output on.
Off
– Switches the output off.
Toggle
– Changes the state of the output each time
you press the button.
4.
Press
repeatedly to exit.
Deleting remote controls
You may want to delete a remote control if is lost or you want to reassign it
to another user. You must delete a remote control before you can reassign
it to another user.
The
System Config
– Remotes
menu provides two options for deleting
remote controls:
Delete
This allows you to delete a specific remote control (see
below).
Delete All
This deletes all remote controls that the system learnt.
You should use this option only if you are sure you want
to delete all remote controls.
