User Menu Options
Page 46
Testing user HUDs
Master and admin users can use
Test
– User HUDs
to test radio hold-up
devices.
To carry out the test:
1.
Select
Test
– User HUDs
.
The following is displayed:
2.
Press and hold both buttons on the device you wish to test until the
transmit LED on the device flashes. If the device has a lock button,
make sure you unlock the button before the test.
The keypad gives a double-beep confirmation tone and you will see
the results of the test:
The top line shows the name of the user the device is allocated to.
The bottom line shows the strength of the signal. If the signal strength
is less than 4, contact your installer.
3.
Repeat step 2 for the other user hold-up devices.
4.
Press
to end the test.
Testing proximity tags
Master and admin users can use
Test
– Prox Tags
to test proximity reader
tags.
To carry out the test:
1.
Select
Test
– Prox Tags
.
The following is displayed:
2.
Hold the proximity tag against the proximity tag sensor on the keypad.