Test Menu
Page 133
DNS IP Address
This is the IP address of the DNS server used by the control unit.
MAC Address
This is the unique MAC address of the control unit PCB. Each control unit PCB will
have an individual MAC address.
IP Link Status
This option shows the current status of the Ethernet link between a PC and the
control unit. The display shows “Fail” when there is no link, and “OK” when the
Ethernet link is established. Note that “OK” only shows that the link is established, it
does not show that the PC is logged into the control unit.
Module
For a GSM module, this provides:
Network
– Network name and signal strength.
IMEI
– IMEI number of the SIM card in use.
IMSI
– International Mobile Subscribed Identity (IMSI) to identify the GSM
subscriber.
Version
– The firmware version of the module.
Reset
– Resets the module.
For a PSTN module, this provides
PSTN Link Status
, which shows the current status of
the PSTN connected to
the control unit. The display shows “Fail” when there is no link, and
“OK” when there is a PSTN line available. Note that “OK” only shows that the line is
available; it does not show if a call is possible.
Zone Mapping
This option allows you to check which zones are currently allocated to detector connection
points, or which detector connection points have zone numbers allocated.
Zone Numbers
This shows a list of zone numbers (with names), with detector connection points for each
zone.
Zone Addresses
This shows a list of detector connection points, with zone numbers and names, where
allocated. (For an explanation of zone numbers see page 26.)
