Page 132
Chapter 13: About Menu
The
About
menu offers information on the version and status of the control unit and
information about any modules fitted.
Panel
This option shows:
The control unit model.
The
control unit’s software revision.
Whether the control unit is programmed as partition or part setting.
The installed languages and their versions.
Press
or
to see each item of information.
Expanders
This option shows the first item in list of all the expanders known to the control unit. If you
select an expander by scrolling up or down the list and then press
, the display shows
the revision of software running on the expander.
Keypads
This option shows the first item in a list of the keypads known to the control unit. If you
select a keypad by scrolling up or down the list and then press
, the display shows the
revision of software running on the keypad.
If you find that the
Keypad
option does not d
isplay an individual keypad’s software version,
you can check the keypad by
briefly
pressing the “A” and “
” keys at the same time.
Comms
The contents of this option depend on the plug-on communications module fitted to the
control unit. When no module is present, the
Panel Ethernet
option is the only one visible.
Panel Ethernet
This shows information about Internet Protocol (IP) settings used by the control unit itself.
You will need this information when you set up an Ethernet connection from a PC to the
control unit in order to use the built in web browser interface. To change the settings use
the
Communications
– IP Network (Own)
menu (see page 116).
IP Address
This is the IP address the control unit uses when linked by Ethernet to a PC.
IP Subnet Mask
This is the subnet mask currently in use by the control unit itself.
Gateway IP Address
This is the gateway address being used by the control unit.
