Eaton i-on Compact, Administration And User Manual

Page: 46 / 63

User Menu Options
Page 42
Testing remote controls
Master and admin users can use Test
– Remotes
to test remote controls.
To carry out the test:
1. Select Test
– Remotes
.
The following is displayed:


2. Press and hold a button on the device you wish to test until the
transmit LED on the device flashes.
The keypad gives a double-beep confirmation tone and you will see
the results of the test:


The top line shows the number of the device, the button you pressed,
and the name of the user the device is allocated to. The bottom line
shows the function of the button and the strength of the signal. If the
signal strength is less than 4, contact your installer.
3. Repeat step 2 for the other buttons. Note: If you wish to test the Hold-
Up Alarm buttons, make sure you press them both at the same time.
4. Press

to end the test.
Testing user HUAs
Master and admin users can use Test
– User HUAs
to test radio Hold-Up
Alarm (HUA) devices.
To carry out the test:
1. Select Test
– User HUAs
.
The following is displayed:


2. Press and hold both HUA buttons on the device you wish to test until
the transmit LED on the device flashes. If the device has a lock
button, make sure you unlock the button before the test.