Eaton Holec Capitole 40, User Manual

Page: 43 / 101

Capitole 40
1991.901 G01 002 43
3.1.5 Fitting a draw-out unit (draw out unit
with fixed cover)
•
Put the switch in the off position.
•
When inserting a draw-out unit the bottom-plate should
slide over the H-shaped profile on the fixed part.
•
Insert the draw-out unit in fully whilst depressing the
catch 1) (see Figure 3-4)
•
After releasing the catch 1) the draw- out unit is
interlocked and ready for operation. (see Figure 3-5).
N
OTE
By tray’s over the width of the compartment 2
locking levers.
Figure 3-4: Insert draw-out unit
Figure 3-5: Draw-out unit interlocked
3.1.6 Removal of a draw-out unit (draw out
unit with fixed cover)
•
Put the switch in the off or moving position.
•
Disengage the locking-system by pressing the catch 1)
in the handle.
O
PMERKING
By tray’s over the width of the compartment 2
locking levers.
•
Pull out the unit and remove it from the cubicle..
A
TTENTION
The draw-out units are not provided with a side-
catch (interlocking).
Figure 3-6: Removing the tray