Eaton Fuller FSO-2405, Service Manual

Page: 124 / 163

124
Front Section Disassembly
4
Front Section
2nd Ed. 02/07
FSO-2405
FSO-2405/109
FSO-2405/110
1
1
2
3
2
Shift Yoke Bars
Disassembly
1. Remove the retaining roll pins and remove the
parts from the shift bars.
NOTE: Use a 4 mm diameter pin punch.
2. If necessary, replace the shift yoke permaglide
bushing. After installing the bushing, use a
punch to lock the bushing in the bushing bore.
Be careful not to damage the shift yoke.
3. If necessary, replace the shift yoke nylon pads.
1st/2nd and 3rd/4th Speed Yoke Bar
Assembly
1. Make sure the shift block is properly positioned
regarding the notch at the yoke bar end and
install the shift block on the yoke bar.
2. Make sure the 3rd/4th speed shift yoke is
properly positioned regarding the notch at the
yoke bar end and install the shift yoke on the
yoke bar.
3. Align the shift yoke with the yoke bar matching
the roll pin holes and install the retaining roll
pin. Push the roll pin until it is flush with yoke
hub.
NOTE: See “Special Tools”, Ref. E001044.
4. Align the shift block with the yoke bar matching
the roll pin holes and install the retaining roll
pin. Push the roll pin until it is flush with shift
block hub.
NOTE: See “Special Tools”, Ref. E001044.
NOTE: Replace the roll pin by a new one.