![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operation-manual_524480021.webp)
Installation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
13
Optional Accessories
Optional Environmental Monitoring Probe (EMP) equipment with sensors can be connected to the ePDU as an
accessory. The equipment is customer-supplied and should be installed using the manufacturer’s instruction
manual.
!
IMPORTANT
Follow all installation and operation safety information provided in the manufacturer’s instruction
manual for the EMP equipment. Use only supplied accessories.
1
Installation Pack for all models:
(1) Blue and (1) Red Arrow to indicate power source flow
(2) Spare black plastic key hole buttons, (2) M4 screws (thread-forming), and (2) M4 nuts
(4) M6 Cage nut, (4) M6 dome screws, and (2) M6 Flat head screws
(2) Clip feet and (2) M6 Flat head screws
NOTE
You may also have (2) M4 spare screws.
1
Network Pack for Network-connected models only:
l
(1) Serial cable used for RS-232 connection between the ePDU and a PC
l
(1) RJ-45 Cable (60cm - shielded) used for Ethernet or daisy-chain connection between the ePDU and a PC
SEE NOTE
l
(1) Y Splitter installed in the Daisy-chain port and used for daisy-chaining three or four ePDUs together,
NOTE
The short Ethernet cable is intended for setup or daisy chain. Longer standard network cables can be made or purchased separately.
NOTE
Some ePDUs have detachable power cords which may or may not be included. Check specifications prior to ordering.
Table 2. Shipped with the ePDU in the Shipping Carton(Continued)
Quantity
Description