![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operation-manual_524480127.webp)
Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
119
7.
Type the IPv6 gateway address (if any).
8.
Type the second IPv6 address and prefix.
9.
Click
Save
.
10. Open the System page. In the Network Management Card panel, click
Restart network management
card
to restart the eNMC module. A pop-up confirmation message displays:
Are you sure you want to restart the Network Management Card?
Note: This will NOT restart the ePDU or change the power status of the outlets.
Configure the DNS
When the IPv4 address is automatically obtained by DHCP, the DNS server addresses (primary and secondary)
are provided by the DHCP server.
You can define DNS IPv4/IPv6 addresses from the Web and Serial interfaces. However, this configuration is
overwritten when the ePDU Network Management and Control (eNMC) module restarts and the IPv4 address
is obtained from a DHCP server that provides DNS addresses.
1.
Access the Web interface and log in.
2.
Under Network, select TCP/IP. The TCP/IP page displays.
3.
In the DNS panel, type the primary DNS server’s IPv4 or IPv6 address.
4.
Type the secondary DNS server’s IPv4 or IPv6 address (if any).
5.
Click
Save
.
Configure the SMTP
1.
Access the Web interface and log in.
2.
Under Network, select TCP/IP. The TCP/IP page displays
3.
In the SMTP panel, type the SMTP server IPv4 / IPv6 address or host name.
4.
If not already provided, type the SMTP port.
5.
If your SMTP server requires authentication, perform the following:
l
Check the SMTP Server Authentication check box.
l
Type the login.
l
Type the password.
l
If not already provided, type the sender address.
6.
Click
Save
.