Eaton EFX48 e-Fuse Series, Installation And Operation Manual

Page: 84 / 161

EFX48-xx Series with RM3-340/440 Installation and Operation Guide
84
Copyright © 2019 Eaton Corporation. All Rights Reserved.
IPN March 2019
Communication via Web Browser
The EFX48 system controller has an in-built web server. This allows a Laptop/PC with a
standard web browser to control and monitor the EFX48 via an Ethernet network.

Only one connection to an EFX48 can be made at any time. The EFX48 does not
support multiple sessions.
►
To connect to the EFX48 with a web browser:
1
Set up Ethernet communications and connect the EFX48 to the network. See Ethernet
Communications on page 87.
2
Open a web browser window.
 Recommended web browsers: Firefox 58, Chrome 69, Safari 10 or later.
3
Type the IP address of the EFX48 into the address bar of the browser.
 If HTTPS access has been enabled then type "https://" before the IP address.
4
The browser will prompt you to enter a username and password in order to access the
EFX48.
5
A username and password is required.

Factory defined Username (efx48) and Password (joAdPoc4) must be entered. These
can be changed, and can be more or less complex
.
6
Click
OK
. The EFX48 web system page will be displayed.