Eaton EC500, Operation Handbook

Page: 86 / 107

EC500 Controller Handbook Communications
Copyright © 2019 Eaton Corporation. All Rights Reserved.
Issue A March 2019
Page 86 of 107
Parameter Description Range, Default Value Where to find:
Trap Receiver
Status Configure if the
respective Trap receiver
is Enabled or Disabled. Enable
Disable
Default: Enable
Home> Settings>
Communication
Settings>SNMP>Trap Receiver
x >Status
Trap Community
Set Trap community
accepted by respective
Trap receiver. Contact
your NMS manager for
correct Trap Community. *****, (string, len 15) Home> Settings>
Communication
Settings>SNMP>Trap Receiver
x >Community
Trap Receiver IP
Address Type
Select IP address type of
the Trap receiver. IPv4
IPv6
Default: IPv4
Home> Settings>
Communication
Settings>SNMP>Trap Receiver
x >IP Address Type
Trap Receiver IP
Address
Set IP address of the Trap
Receiver. Contact your
NMS manager for correct
IP address. Valid IPv4 or IPv6
address Home> Settings>
Communication
Settings>SNMP>Trap Receiver
x >IPv4 or IPv6
Trap Receiver
Port number Set Port receiver on
which respective Trap
receiver is listening.
Contact your NMS
manager for correct port
number. 0 -65535,
Default: 162
Home> Settings>
Communication
Settings>SNMP>Trap Receiver
x >Port
All Traps will be sent to both Trap receivers, if enabled.
SNMPv3 Trap Configuration
EC500 supports up to 8 Trap Receivers for SNMPv3 Traps. Set following parameters for each of these Trap
receivers, when SNMP Access Type is set to SNMPv3. Following three security models are supported.
NoAuthNoPriv: No Authentication and no Privacy
AuthNoPriv : Authentication, no Privacy
AuthPriv : Authentication and Privacy both are applied
Parameter Description Range, Default
Value Where to find:
User Name Security Model name for
Manager access. A blank user
name disables the user. Only
one user with Read only access
is defined by default. ******, (string,
len 31) Home> Settings>
Communication
Settings>SNMP>SNMPv3
USER>USERx>Username
Security Model Select security model.
NOAUTHNOPRIV
AUTHNOPRIV
AUTHPRIV
Default:
AUTHPRIV
Home> Settings>
Communication
Settings>SNMP>SNMPv3
USER>USERx>Security Type