Eaton easyE4 series, Manual

Page: 123 / 621

4. Operation
4.6 Transfer program to the easyE4 device
4.6.2 Establish Ethernet connection
Establishing a connection between a PC and an easyE4 base device
In order to be able to establish a connection, your PC must first have the required Eth-
ernet capability. This capability can be in the form of a local Ethernet port on the PC or a
standard adapter (e.g., USB-to-Ethernet adapter).
The PC's and the easyE4 base device's IP addresses must fall within the same range,
i.e., the addresses' first two or three numbers must be the same, while the last number
must be different and not equal to 0.
Check the easyE4 device's IP address.
To do this, open the
INFORMATION\ACTUAL CONFIG menu and scroll to IP
ADDRESS.
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM
Table 46: Main menu
ACTUAL CONFIG
SYSTEM
Table 47: Information
NET-GROUP: 00
NET-ID: 00
MAC ADDRESS:
xxxxxxxxxxxx
DEVICE NAME:
IP ADDRESS
xxx.xxx.xxx.xxx
SUBNET MASK
000.000.000.000
GATEWAY ADDRESS
000.000.000.000
DNS SERVER
000.000.000.000
WEB SERVER:
✓
HTTP PORT:
MODBUS TCP:
KEEPALIVE:
0060
Table 48: Information\Actual Config
If an IP address has not been assigned yet, enter one.
To do this, open the
SYSTEM OPTIONS\ETHERNET\IP Address menu.
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM
Table 49: Main menu
SECURITY
SYSTEM
MENU LANGUAGE
DELETE PROGRAM
NET
ETHERNET
Table 50: System options
ADDRESS MODE
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
DNS SERVER
Table 51: System option-
s\Ethernet
IP ADDRESS
000.000.000.000
Table 52: System Option-
s\Ethernet\IP Address
Use the cursor buttons to enter the device's
IP address.
easyE4 11/18 MN050009 EN www.eaton.com
119