Eaton easy500, easy700, Operating Instructions Manual, Page: 63 / 240

4 Wiring  with
4.1 -operation
Operating instructions 05/10 MN05013003Z-EN www.eaton.com
59
4 Wiring  with
By working through the example in chapter 3 you should now have gained an
initial impression of just how simple it is to create a circuit diagram in easy.
This chapter describes the technical overview of easy functions and provides
further examples of how to use easy.
4.1  -operation
4.1.1 Buttons for editing circuit diagrams and function relays
4.1.2 Operation
The cursor buttons in the easy circuit diagram perform three functions. The
current mode is indicated by the appearance of the flashing cursor.
• Move
• Enter
• Connecting
In Move mode, use ÍÚ ú í to position the cursor on the circuit diagram in
order to select a rung, a contact or a relay coil.
Use OK to switch to Entry mode so that you can enter or change a value at
the current cursor position. If you press ESC in Entry mode, easy will undo
the most recent changes.
Press ALT to switch to Connect mode for wiring contacts and relays. Press
ALT again to return to Move.
Delete rung, contact, relay or empty rung in
the circuit diagram
Toggle between N/C and N/O contact
Connect contacts, relays and rungs
Add rungs,
ÍÚ
ú í
Change value
Move cursor up/down
Change place
Cursor left/right
Cursor buttons set as P buttons:
ú
í
Input P1,
Input P3,
Í
Ú
Input P2
Input P4
Undo setting from last OK
Leave current display, menu
Change, add new contact/relay,
Save setting
â
I 1
l