26. Reattach the backlight cable to the inverter board. Ensure that the two wires are on either side of the
small white standoff. See Figure 12.
27. Reattach the inverter board. Make sure the wires are routed through the cable clip.
Standoff
Inverter
Board
Inverter
Power Cable
Backlight
Cable
Cable Clip
Figure 12
28. Reconnect the inverter power cable to the inverter if it was removed.
29. Should the touchscreen wire bundle need to be reconnected to the touchscreen controller card, make
sure the connector labeled “TS” is connected to the touchscreen board and is facing out.
30. Verify that all previous connections are in place. See Figure 5.
31. Reattach the slot bracket using the five flat-head screws.
32. Reinstall the motherboard, screwing the four screws into the standoffs. If the screw holes on the right
are slotted, then the screws with flat washers should be used.
33. Reattach the power wires if they were removed. The black wire is on the extreme left and the red
wire is on the extreme right. See Figure 5.
34. Reinstall the CPU circuit board into the slot closest to the display panel making sure that it is fully
seated.
35. Reattach the black display cable to the CPU circuit board making sure most of the wires are to the
right (away from the fan) and taking care to center it on the pins without bending any. See Figure 4.
Caution
: If the display cable is not aligned correctly on the pins, the display and CPU can be
damaged beyond repair during power-up.
36. Reattach the red and white touchscreen wire bundle to the CPU circuit board making sure the red
wire is to the left (toward the fan) and taking care to center it on the pins without bending any. See
Figure 4.
37. Reinstall the connector plate with USB and serial expansion connectors next to the CPU board. Be
careful to avoid the protruding screw. Reinstall the remaining slot protector.
38. Reconnect the fan cable to the connector and tuck the cables and connectors back in making sure
the wires remain clear of the fan.
39. Verify that all previous connections are in place. Reinstall the chassis cover.
40. Connect the power source cable and any other cables.
January 2006
Page 9 of 14
01-50604-01
