Replacing the PanelMate
T
ePro
E
7685x-8 and 7585x-8 Series,
PanelMate Power Pro 1785 Series Backlight Assembly
Instruction Leaflet IL04802008E
Effective September 2008
Introduction
The Backlight Replacement Kit provides a replacement backlight for
the PanelMate ePro 7685x-8 PS Series, the PanelMate ePro 7585x-8
Series, and the PanelMate Power Pro 1785 Series. Although the fig-
ures provided are for touchscreen models, disassembly for keypad
models is similar. For bulb replacement in keypad units, follow the
same procedures as for touchscreen units.
Contents
●
Backlight
●
Disposable Grounding Wrist Strap
Required Tools
●
Phillips screwdriver — size P0 and P1. Magnetic would be helpful.
●
Nut Driver or socket size 1/4-inch.
●
Jewelers small Phillips screwdriver. Magnetic would be helpful.
m
CAUTION
ELECTROSTATIC DISCHARGE (ESD) CAN DAMAGE STATIC-SENSITIVE ELEC-
TRONIC COMPONENTS. YOU SHOULD PERFORM THESE PROCEDURES ONLY AT
AN ESD WORKSTATION. IF AN ESD WORKSTATION IS NOT AVAILABLE, YOU
CAN PROVIDE SOME PROTECTION BY WEARING AN ANTI-STATIC WRIST STRAP
AND ATTACHING IT TO A METAL PART OF THE SYSTEM CHASSIS.
m
WARNING
THIS PROCEDURE REQUIRES ELECTRICAL AND MECHANICAL SKILL AND
SHOULD BE ATTEMPTED ONLY BY QUALIFIED TECHNICIANS.
Disclaimer of Warranties and Limitation of Liability
The information, recommendations, descriptions and safety notations
in this document are based on Eaton Electrical Inc. and/or Eaton
Corporation’s (“Eaton”) experience and judgment and may not
cover all contingencies. If further information is required, an Eaton
sales office should be consulted. Sale of the product shown in this
literature is subject to the terms and conditions outlined in appropri-
ate Eaton selling policies or other contractual agreement between
Eaton and the purchaser. THERE ARE NO UNDERSTANDINGS,
AGREEMENTS, WARRANTIES, EXPRESSED OR IMPLIED, INCLUD-
ING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR
MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET
OUT IN ANY EXISTING CONTRACT BETWEEN THE PARTIES. ANY
SUCH CONTRACT STATES THE ENTIRE OBLIGATION OF EATON.
THE CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART
OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES.
In no event will Eaton be responsible to the purchaser or user in
contract, in tort (including negligence), strict liability or otherwise
for any special, indirect, incidental or consequential damage or loss
whatsoever, including but not limited to damage or loss of use of
equipment, plant or power system, cost of capital, loss of power,
additional expenses in the use of existing power facilities, or claims
against the purchaser or user by its customers resulting from the
use of the information, recommendations and descriptions
contained herein.
The information contained in this manual is subject to change
without notice.
IL04802008E.fm Page 1 Friday, September 19, 2008 3:21 PM
