background image

Adapter Plate Kit – APPS12A 

For replacing a PanelMate® 4000/5000 TouchPanel unit with a 

PanelMate ePro PS 12” Display unit 

Introduction 

This Adapter Plate Kit (APPS12A) allows you to mount a PanelMate ePro PS 12” display unit 
(7685T-12 series) in a location previously occupied by a PanelMate Power Series 4000/5000 
TouchPanel unit (45xx/55xx series) or a PanelMate Power Pro 5000 TouchPanel unit (55xx/57xx 
series). 

This Adapter Plate Kit includes the following items: 

• 

1 Adapter Plate 

• 

1 Gasket 

• 

18 #10-32 Star Nuts 

• 

18 #10 Washers 

Required Tools

:  Torque driver with 3/8” socket 

Installation 

Follow the steps below to properly assemble and mount the Adapter Plate Kit. 

1.  Attach the gasket to the adapter plate. With the paper side facing the plate, align the outside 

edge of the gasket with the outside edge of the plate. Attach the gasket by peeling the 
protective paper from the gasket, exposing the adhesive, a few inches at a time. 

2.  Mount the PanelMate ePro PS unit to the adapter plate. Place the PanelMate ePro PS unit face 

down on a clean work surface. Avoid any objects or motion that could scratch the front panel. 
Guide the plate onto the unit. Secure the plate by installing the nuts and washers provided with 
the unit. 

Note

: The torque limit for these studs is 15 inch-pounds for #10-32 nuts. 

3.  Install the adapter plate with the attached unit into the existing panel opening and secure it with 

the #10 washers and locking nuts provided with this kit. 

Note

: The torque limit for these studs is 20 inch-pounds for #10-32 nuts. 

CAUTION

CARE SHOULD BE EXERCISED WHEN TIGHTENING THE NUTS.  THE FASTENERS MUST BE 
TIGHTENED ENOUGH TO OBTAIN A PROPER SEAL, BUT NOT TIGHTENED TO THE POINT WHERE 
THE THREADS ARE STRIPPED OR THE GASKET IS OVER COMPRESSED AND RENDERED 
USELESS. 

 

 

January 2005 

Page 1 of 2 

01-50610-00 

 

Reviews: