System Controller
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-52D July 2010
41
►
To use a web browser for Restore (SC200 only)
1
Connect to the SC200 via a web browser. For details see Ethernet Communications in the
System Controller Operation Handbook.
2
Go to
Tools
.
3
Select
Restore Tool
.
4
Select the file type:
•
System Snapshot (*.dcs):
Configuration file including site specific settings.
•
Configuration (*.dcc):
Configuration file without site specific settings - Site Identity, IP
Address, S3P Address, battery characterization data).
•
Fragment (*.dcf):
Restore part of a configuration file (such as battery characterization
data).
5
Click
Next
, and then select a file name to
Restore
a configuration.
Starting the SC200 or SC100
When dc power is applied to the SC200 or SC100 (via the RXP connector YS11) the start-up
sequence begins.
SC200
Î
Approx.
120s
Î
Í
Start-up screen
Main screen
Menu screen
The values shown are
configurable, see details in
the System Controller
Operation Handbook. All
active Critical, Major,
Minor and Warning alarms
are displayed.
See navigation details on page
.
If Logon is required see
Keypad Access Security on
page
.
