Eaton 9910-E16, Installation Manual

Page: 23 / 274

OPERATION
EATON 9130 (9910-E15/E16) UPS Installation Guide for IBM ® Applications
S
164201783 Rev 2 23
Starting the UPS on Battery
NOTE
Before using this feature, the UPS must have been powered by utility power with
output enabled at least once.
NOTE
Battery start can be disabled. See “User Settings” in the UPS user's guide.
To start the UPS on battery:
1. Press the button on the UPS front panel until the UPS front
panel display illuminates and shows a status of “UPS starting...”.
The UPS cycles through Standby mode to Battery mode. The
indicator illuminates solid. The UPS supplies power to your
equipment.
2. Check the UPS front panel display for active alarms or notices
besides the “UPS on Battery” notice and notices that indicate
missing utility power. Resolve any active alarms before continuing.
Refer to “Troubleshooting” in the UPS user's guide.
Check the UPS status from the front panel to view the active
alarms. Correct the alarms and restart if necessary.
3. Press the
ESC
button until the start screen appears.
UPS Shutdown
To shut down the UPS:
1. Press the button on the front panel for three seconds.
The UPS starts to beep and shows a status of “UPS off pending...”.
The UPS then transfers to Standby mode, and the
indicator
turns off.
NOTE
Releasing the button before three seconds returns the UPS to its original
operating mode.
2. Switch off utility power where the UPS is connected.