The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols. This document is written for a
global reader.
CAUTION
Read this document before you start to operate or do work on the UPS.
2.3
CE marking
The product has a CE marking in compliance with the following European
directives:
•
LVD Directive (Safety) 2014/35/EU
•
EMC Directive 2014/30/EU
•
RoHS Directive 2011/65/EU
Declarations of conformity with UPS harmonized standards and directives EN
62040-1 (Safety), EN 62040-2 (EMC) and EN 50581 (RoHS) are available at
www.eaton.eu or by contacting your nearest Eaton office or authorized partner.
2.4
User precautions
The only permitted user operations are as follows:
•
Startup and shutdown of the UPS, excluding the commissioning startup.
•
Use of the LCD control panel and the Maintenance Bypass Switch (MBS).
•
Use of optional connectivity modules and their software.
Follow the precautions and only perform the described operations. Any deviation
from the instructions can be dangerous to the user or cause accidental load loss.
DANGER
Do not open any other screws in the unit than those holding the cover
plates of the MiniSlots and the MBS locking plate. Failure to recognize
the electrical hazards can prove fatal.
© Eaton Corporation plc 2020. All rights reserved.
Revision: 006
Document ID: P-164000493
15 (126)
Eaton 91PS/93PS UPS 8–40 kW
User’s and Installation Guide
