614-40099-00
14
A small amount of arcing may occur when
connecting an EBM to the UPS. This is normal and will
not harm personnel. Insert the EBM cable into the UPS
battery connector quickly and firmly.
1. Attach the UPS and the EBMs to each other using the
supplied mounting plate. Up to 4 EBMs may be
connected to the UPS.
2. Connect the EBMs power cable and the attached
battery detection cable as shown in the picture
3. Verify that the EBM connections are tight and that
adequate bend radius and strain relief exist for each
cable.
3.4 UPS connection
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source
and the true electrical consumption of the total load.
1. For the 5PX 1000 / 1500, connect the UPS input socket
(2) to the AC power source using the cable of the
protected equipment.
For the
5PX2000 / 2200
/ 3000, connect the UPS input
socket (2) to the AC-power source using the cable (31)
supplied.
2. Connect the loads to the UPS using the cables (14). It is
preferable to connect the priority loads to the
outlets marked (3) and the non-priority loads to the
outlets Group1, Group2 (4) that can be programmed.
For the 5PX 2000 / 3000 models, connect any high-power
devices to the 16A outlet.
Fit the connection securing system that prevents the
plugs from being pulled out accidentally.
3. To program shutdown and startup of the Group1 and
Group2 outlets in order to extend battery runtime,
perform scheduled shutdowns, please see the "
