EL-SIE
Easylog
Quick Start Guide
Getting to Know Your EL-SIE Logger
Access Screws
Display
Connect to your PC or Mac
Function
Buttons
USB Port
Install the Batteries
The unit is powered by two user replaceable
non-rechargeable AM alkaline batteries.
Other battery types are not recommended.
Loosen the screws and remove the end
cap, then fit the batteries in the orientation
shown on the label. Replace the end cap
and tighten the screws carefully until
secure.
No software is needed! To configure, view and analyse the data from your EL-SIE, simply follow these steps:
1. Connect the logger to your computer using the USB cable supplied
2. Open your web browser and into the address bar type http://EasyLog.local
3. The EL-SIE home page will load - save it to your Favourites or Bookmarks
4. Follow the on-screen instructions to configure and start logging
5. Disconnect the logger and position it where you want to take readings
Once the logger is running you can plug it back into your computer and, without having to stop it logging,
view the data recorded so far.
Configure Data Logger Settings
Easylog Cloud Data Storage
Store your data securely, and make it available from
any internet-connected computer or mobile device, with
Easylog Cloud. The EL-SIE can send logged data to the
Cloud from your computer or Mac,
making sharing and analysis easier
than ever.
CALIBRATION CERTIFICATES AVAILABLE
Lascar offers a Traceable Calibration Certificate Service on Temperature Data Loggers. Using reference equipment
which has been calibrated by a UKAS/NIST/CNAS accredited laboratory and using apparatus traceable to national
or international standards.
www.
GlobalTestSupply
.com
Find Quality Products Online at: