EasyIO FG32 – Installation Guide v2.0
18
Changing IP address
By default the EasyIO FG and FG+ Series controller IP address is 192.168.10.11.
Changing the IP address can only be done through CP T tools.
Step 1
Login to the FG32 via Sedona workbench. Locate the object
“IP”
under the Service folder.
Step 2
Click IP object and view properties at the side bar.
At the
newIpAddress
,
newSubnetMask
and
newGateway
property, enter your new IP address.
Inserting invalid values to these properties will brick the network settings.
A restore factory default is required if controller unable to connect.
currentDhcp
and
newDhcp
property only supported by FS Series controllers.
Ignore these properties if the hardware is FG and FG+.
