MIG WELDER /
PLASMA CUTTER CART
INSTRUCTIONS
Part #20232
Page 1: ...MIG WELDER PLASMA CUTTER CART INSTRUCTIONS Part 20232 ...
Page 2: ...nd bottom Never push or pull cart by the cylinder as it could tip over Use cart on level surfaces only Do not use on sloped surfaces Always push pull and steer the cart by the top shelf only and be aware that the weight of a welder will cause it to be top heavy Do not push or pull by the welder case as it could tip over Do not pull cart by the welder s gun or ground cable as it could cause tip ove...
Page 3: ...enter Shelf F holes with 4 holes in the Shelf Side Support Rails H 2 Insert 4 bolts bolt in both sides from the outside in Attach washers and nuts over the threads protruding through 3 Align the Center Shelf F holes with 2 holes in the Rear Vertical Panel E 4 Insert 2 bolts bolt in both sides from the rear of the panel inward Attach washers and nuts over the threads protruding through 5 Tighten nu...
Page 4: ...t seem to align Make sure that all of the bolts are only finger tight and once the entire cart is assembled go back and tighten each of the bolts The Caster Wheels do not swivel 360 Make sure the bolts for the Caster Wheels are inserted so that the head of the bolt is on the caster side and the nut is on the Base Shelf Side ACCESSORIES 13203 Auto Darkening Welding Helmet 13212 Large View Auto Dark...
