32
Form E-564
Eastman
®
The Raptor uses one Z Controller card located
inside the Computer. The Z controller card com
-
municates over the purple network cables with
all of the Motor Amplifiers and the Slice Input/
Output (IO) cards. This communication results
in coordinated motion between the Gantry Cut
-
ting Tools and the Conveyor System insuring the
most accurate cutting possible. The Configuration
Files contain parameters for each node on the
network (Controller Card, Amp, Slice IO, etc.).
In the rare case that a Controller Card needs
replacement, the loading of the proper Con-
figuration Files should be done with the help
of Eastman’s Technical Service Department. If
the Raptor Machine’s Computer is hooked up
to the internet, Eastman’s Technical Service
Department has the capability of remotely ac
-
cessing your machine through the internet and
loading the proper files for you. If not, techni
-
cal service can be provided over the phone.
Do not attempt to load the files yourself. Im
-
proper parameters can result in unpredictable
machine operation. This may cause dam-
age to your machine or injury to a operator.
Replacing Multi Axis Controller
Card and Loading Configuration
Files
CAUTION
