28 Maintenance
6. With the parts disassembled, clean the parts as required or determine which
parts need to be replaced.
Upper Seal Bar Pad
Seal pads are designed to be easy to install and replace. They are square and inserted
into the channel extrusion so that if one side is worn, the pad can be repositioned
rotated to use a new side. This way it can be re-used until all sides have been used.
Upper Seal Bar Pad Re-assembly
Reassemble the seal pads, tape, and bands in reverse order of disassembly.
1. Carefully press the silicone pads into the sealer channels. The silicone pads
should be the same length as the channel extrusions into which they are applied
and should meet up with the ceramic corner radius seal band guide.
Seal Band
Teflon Tape
(both sides
of seal band)
Ceramic Bead
Extrusion
Seal Band
Ceramic Bead
Extrusion
Teflon Tape
Teflon Tape
1
2
3
4
Remove
and
Replace
Silicone
Pad
Initial
Use
Period.
Second
Use
Period.
Third
Use
Period.
Silicone
Pad
Wear.
Fourth
and
Final
Use
Period.
Rotate
Silicone
Pad
90°,
and
Re-use.
Note
Tape
Wear
or
Damage.
Apply
New
Tape.
Disassemble,
Rotate
Silicone
Pad
90°,
and
Re-use.
Disassemble,
Rotate
Silicone
Pad
90°,
and
Re-use.
Disassemble,
Apply
New
Tape.
Summary of Contents for L-Bar Sealer Tunnel Combo Unit Value Series
