Operation 21
Blower Speed
Use the “Blower SPEED” dial to set the air flow inside the shrink tunnel.
The blower speed will vary according to the product dimensions and film
properties.
Conveyor Speed
Use the “Conveyor SPEED” dial to set the conveyor speed through the
shrink tunnel. The conveyor speed will vary according to the product
dimensions and film properties.
E-Stop or Emergency Stop
A red E-Stop button is placed centrally above the control panel. In the
event of an emergency, press the E-Stop button in. This brings the
system to a halt in a way to avoid damage or excessive film waste.
CAUTION!
When the L-Bar Sealer Tunnel Combo Unit is
stopped or turned off be aware of heat inside of the tunnel and
hot surfaces and moving belts or rollers.
To return the machine back to normal operation once the E-Stop has
been pressed, verify the emergency condition has been cleared, then
press and turn the E-Stop button a quarter-turn so it pops out to
normal operating position.
Emergency Stop
E-STOP
Summary of Contents for L-Bar Sealer Tunnel Combo Unit Value Series
