Eastey EXS-100, User Manual

Page: 14 / 53

14 Installation
Lift the plates (B) to open the top of the machine body and find and remove the
following items from inside.
•
A User Guide packet, which contains the following.
- This User Guide
- An Allen wrench set
- A pair of stop angle brackets with attaching hardware
• A desiccant pouch
CAUTION! The items listed above must be removed from the inside of
the strapper body before powering or operating the strapper.
These items may be retrieved from inside the machine body before or after moving the
strapper to its desired operating location, but they must be removed before powering or
operating the strapper Once these items have been removed, refasten the top work-
surface plates to the top of the machine body using the same flat head socket screws
removed earlier. Instructions are provided later in this section for attaching the stop
angle brackets to the top work surface of the strapper. Do not operate the straper with
top plates removed.
Casters
The strapping machine is equipped standard with four casters (one caster on each of its
four legs). The two casters on the legs at the front of strapping machine are locking
casters. Lift the levers upward to unlock the casters to the machine to allow the machine
to be moved.
Move the strapping machine to the desired location. Casters allow the strapping
machine to be rolled across a smooth, level floor surface. When the strapping machine
has been moved to the desired location, press the lever of each of the two front locking
casters down, to the locked position, to keep the strapping machine from moving.
Location Requirements
When installing the Eastey EXS-100 Semi-Automatic Strapping Machine it is important
to be aware of the following considerations:
1. The floor surface is flat and level where the strapping machine will be placed.
Lock
Unlock