Eastey EC Series, User Manual, Page: 16 / 39

16 Installation
Height Fine-Adjustment and Leveling
For fine-adjustment of the leg length for fine-adjustment of height or for final leveling of
the conveyor, first loosen the 1”-8 UNC standard nut, if applicable, and then twist the
threaded-rod leg into or out of the conveyor leg angle bracket.
Note: An open-end wrench or channel-style wrench with a 1-½”
opening is required for the 1”-8 UNC standard nuts.
Location Requirements
When installing the Eastey EC Series Variable Speed Conveyor please be aware of the
following considerations:
1. The mounting surface is flat and level.
2. Conveyor or packing table height.
3. Alignment with packaging line.
A packing table may be provided at the in feed end where items may be placed before
sending them on to the conveyor. It can also be convenient to have a pack table at the
exit end of the conveyor line. It is essential that the conveyor be at the same
approximate height as other components of the line.
The conveyor should be placed on a flat, level floor so that it does not rock or move. We
recommend that the machine be securely locked in place when used.
Lower
Raise Lower Raise
Lock Unlock Lock Unlock
1”-8 UNC Nut