56 Maintenance
Lower Seal Pad Replacement
Occasionally it will be necessary to replace the sponge rubber on the lower seal bar.
These should be replaced if the following are noted:
•
Gaps in the seal.
•
Weak seals.
•
Improper film cutoff.
To replace pads, do the following:
1. Leave the seal head at the highest position.
2. Disconnect electrical power.
3. Seal pads are designed with a channel for easy replacement.
a. Pull the sponge rubber out of the channel and replace with a new
replacement pad.
b. Press the new pad into the channel.
NOTE: If sponge-rubber is covered with talcum powder, clean the
exterior with a rag.
NOTE: When replacing sponge rubber, press it in to the channel from
side to side, taking care so as not to stretch the material.
Summary of Contents for EA Professional Series
Page 2: ......
Page 4: ......
Page 64: ...64 Appendix B Temperature Setting Specifications Appendix A Electrical Schematics...
Page 70: ......
