Eastey BB-2T, User Manual

Page: 13 / 42

Installation 13
Install Front and Rear Tables
Front and rear tables are identical and therefore interchangeable. Temporarily loosen
socket head cap screws at the locations shown in the following illustration. Align the
keyhole slots in the table flanges with the loosened cap screw heads and position table
with conveyor belts, then re-tighten cap screws to secure table. Install one table at each
end (front and rear) of the conveyor body.
Load the tape heads with tape. (One roll each; follow instructions provided in the Tape
Cartridge User Guide
.)
Optional Mounting For Top Squeezers
Threaded holes are provided on both sides (left and right) of the case taper upper tape
head seat at the locations indicated to fasten optional top squeezers to each side of the
upper tape head seat assembly if they are to be installed.
Two threaded
holes are
provided on
each side of the
upper tape head
seat to fasten
optional case
top squeezers if
they have been
ordered for the
case taper
Socket Head
Cap Screws
Socket Head
Cap Screws