7
The screen will display as shown in Figure 2.1-6
Figure 2.1-6
2.2 Shut Down Mode
The calibrator comes with the Shut Down mode enabled for a time duration set to 30
minutes (displayed for about 2 seconds when the calibrator is initially turned on).
When the Shut Down mode is enabled, the calibrator will automatically shut down
after the time duration has elapsed from the time the last key was pressed. To disable
the Shut Down mode, press
and
simultaneously. To enable the mode, press
and
simultaneously. To adjust the time duration, press
and
simultaneously, the screen will display as shown in Figure 2.2-1,then press
and/or
to adjust the time between 1 and 30 minutes and press
to store the new
duration time (Without pressing any key for 5 seconds, the calibrator will exit
automatically).
Figure 2.2-1
2.3 Backlight brightness Adjustment
To adjust the brightness of backlight, proceed as follows:
1.
Press
and
simultaneously until “BRIGHT” is displayed as shown in
Figure 2.3-1.
