Thank you for your purchase.
Our Customer Support team are available weekdays 8am-5pm on (07) 5476 9227 if you have any further questions.
East Coast Garage Doors Pty Ltd,
ATF The East Coast Trust trading as
EAST COAST GARAGE DOORS & GATES
“Transform Your Entrance”
BSA LIC # 1120991
ABN 37 792 942 498
P.O. Box 8125 MAROOCHYDORE DC QLD 4558
www. eastcoastgaragedoors.com.au
P: (07) 5476 9227
F: (07) 5476 9208
REMOTE HANDSET CODING INSTRUCTIONS
GLIDEROL: TM305C
TO CODE YOUR NEW REMOTE USING THE MOTOR PANEL
If you have access to the motor operating your door, you can use these instructions. However, if the door/gate motor is
shared with other tenants at a residential/commercial complex,
do not
use these instructions.
To code in the remote to operate a SINGLE (1) door ONLY:
1. Ensure your new battery is installed correctly in the new remote
2. Open cover on your CONTROL BOX to access the CONTROL BOX PANEL
3. Press the DOOR LEARN KEY (item 8 on diagram over page) on the CONTROL BOX PANEL once
4. Learn LED light should illuminate (item 8A on diagram over page)
5. Press the remote control button you would like to operate the door for TWO SECONDS, release the button for
TWO SECONDS, then press it again for TWO SECONDS
6. Release the DOOR LEARN KEY (item 8 on diagram over page) on the CONTROL BOX PANEL
7. Press the remote control button to test operation of the door
To code in the remote to operate 2 or 3 DOORS:
1. Remove the cover on each
door’s CONTROL BOX PANEL.
2. Locate the JP1/JP2/JP3 switches (see diagram over) and move the black rubber coil on each control box so that
they correspond to the diagram below:
TO DELETE ALL STORED CODES FROM A DOOR
Do not do this if the door is shared with other tenants at a residential/commercial complex.
1. Press and hold down the DOOR LEARN KEY button for TWELVE SECONDS
2. All remotes will no longer operate the door
