E A R T H X J U M P P A C K
2
Operating Instructions
Failure to follow these instructions may result in damage
to the device!
JUMP STARTING
•
Connect the red jumper cable clamp to the positive post of the vehicle battery
•
Connect the black jumper cable clamp to the negative post of the vehicle battery
•
Plug the jumper cable into the Jump Pack (connector fits one way only)
•
Start the vehicle (repeat if necessary after 30 seconds)
•
Disconnect negative clamp, then positive clamp after vehicle starts (recharge the
Jump Pack after use)
USB Port for Charging/Power Electronic Devices
Press the On/Off button for 1 second, the charge level indicator should light-up which is an
indication the USB port is on. The unit will automatically shut-off after a few minutes of
non-use.
LED Flashlight
Press the On/Off button for 3 seconds to turn on/off the flashlight.
CHARGING
First, connect the 100-240VAC Wall Charger to outlet, second, connect the 5mm round
charge port on top of the Jump Pack, the charge level indicator light should start to cycle
which is an indication the unit is charging. When all the charge level indicator lights are lit,
the unit is fully charged.
Indicator
1 LED
2 LED
3 LED
4 LED
5 LED
Remaining
Charge (%)
20
40
60
80
100
Specifications
Model: ML-1
Peak “jump starting” Current
400A
Cranking Amps
220A
Battery Capacity mAh/Wh
2000mAh/26.4Wh
USB Output
5V @2.1A
Wall Charger Output
1A @15V
Max Jump Pack Recharge Time
2-3 hours
Weight (power pack only)
0.9 lb. (.4Kg)
Weight (complete with carrying case)
1.4 lb. (.65Kg)
Dimensions (power pack only)
6.5in (L) x 1.3in (W)x 2.6in
(H)/(165mmX33mmX65mm)
Dimensions (complete with carrying case) 8.25in (L) x 2.6in (W)x 3.6in
(H)/(210mmX66mmX92mm)
