background image

Frame

Upper handles

Gauge &

Linkage

Assembly

Handle Shaft

Lower 

Handles

Wheels

Impeller

Gearbox

Axle

Control Rod

Frame Braces

1.

  Remove and identify all loose parts from carton.

#10 X 1-1/4”

Flat Head Screw

 Pt# 52215  

 

   

PAGE 1

EV-N-SPRED

EV-N-SPRED

EarthWay

EarthWay

®

®

2

600A-P

lus

 E

stAtE

 

B

roAdcAst

 s

PrEAdEr

ASSEMBLY and OPERATING INSTRUCTIONS 

Rev. 3-10

HELPFUL HINTS:

 

REVIEW THE DIRECTIONS BEFORE ASSEMBLY

 

;

Make sure the 

ARROW

 on the gear box points to the front of the spreader. The impeller must turn clockwise.  Reversing  

the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer stuck on the 

impeller blades will cause uneven spreading.

 

;

Your  spreader is designed to be pushed at three miles per hour, which is a brisk walking speed.  Slower or faster speeds 

will change the spread patterns.  Wet fertilizer will also change the spread pattern and flow rate.  Clean and dry your 

spreader thoroughly after each use.  A coating of light spray oil will help prevent corrosion.  Wash between the shut off 

plate and bottom of the hopper.

 

;

Gears are permanently lubricated at the factory.  Do not open the gearbox or dirt may enter.

IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING 

THE SAFE OPERATION OF THIS SPREADER, PLEASE CONTACT US.  THIS MODEL INCLUDES 

LIFETIME TECHNICAL 

SUPPORT

 

SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, 

EmAil

tEchsuPPort

@

EArthwAy

.

com

2. 

Position hopper as shown to the right.  

Install Frame using (4) #10 x 1¼” Flat 

Head Phillips screws.  

TIGHTEN 

THESE NOW 

3. 

Install gear box by inserting the pinion shaft into hole in center of 

hoppers bottom. The 

ARROW

 on the gearbox must point to 

FRONT 

of 

the hopper.  Follow label instructions on hopper.  

FRO

NT

Arrow

Reviews: