Jacks & Signal Path
The audio jacks are located on the north side of the pedal, along with the 9v 410ma power jack.
• The Avalanche Run has a stereo analog dry path, a dual mono delay path and a stereo reverb.
• To run mono; use the left input and output only.
• To run stereo; through use both left and right inputs and outputs.
• To run mono in and stereo out; use the left input and both left and right outputs.
Cool Trick:
Plugging into the right input and using the left and right outputs will give you an all-wet left
channel and a standard mixed right channel while the effect is engaged. You can create dramatic stereo
effects by keeping the Mix set low and turning up the amplifier source connected to the left output. The left
output will not pass dry signal when the effect is turned off in true bypass mode but in tails mode it will still
produce the effected signal as long as it is set to decay.
The expression jack is located on the west side of the pedal. It is a TRS jack with the tip acting as the wiper.
• We recommend using a Moog expression pedal with the output adjustment knob all the way up.
• We cannot guarantee any other expression pedal to work with the Avalanche Run.
Power Requirements
• For best results, please use the included 9v center-negative 1-amp DC power supply.
• Current Draw:
410mA
Flexi-Switching
This device features Flexi-Switch
™
Technology! This relay-based, true bypass switching style allows you to
simultaneously use momentary and latching-style switching.
• For standard latching operation, tap the footswitch once to activate the effect and then tap again to
bypass.
• For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you
release the switch, the effect will be bypassed.
Since the switching is relay-based, it requires power to pass signal.
Tech Specs
• 24-bit 96kHz A/D & D/A converters
• 115dB Typical signal to noise
• Input impedance: 1M Ohm
• Output impedance: 100 Ohm
• All analog dry signal path
• All digital wet signal path with 20hz-20kHz Frequency response
• Selectable relay-based true bypass or buffered analog tails modes
• PCB’s populated by a combination of artificial and human intelligence in the Akron, Ohio of America.
• Each and every Avalanche Run is completely assembled, wired and tested by total human beans in the tiny
tundra town of Akron, Ohio.
Warranty
This device has a limited lifetime warranty. If it breaks, we will fix it. Should you encounter any issues, please
.
