Programming UltraLITE – Printable
Instructions
Clearing the “Main” Headset
When programming a
repaired
or
replaced
unit, the “Main” headset
needs to be
Cleared
before a “Remote” UltraLite or UltraPAK can be
paired. Follow the steps below to clear the “Main”. All Remote headsets
should be “OFF” before starting this process.
1.
Install battery in “Main” headset and turn power switch “ON”.
2.
Press and
hold
programming button (Blue LED) on “Main” headset
for five seconds. The LED will begin flashing blue/red.
3.
Press the programming button (Blue LED) 7 times. The LED will
begin to blink blue. The “Main” headset is now cleared and is ready to
be paired to a Remote headset or UltraPak belt pack.
-Start at step 2 of “Ultralite / UltraPak Programming Instructions”
below
UltraLite / UltraPak HD Programming Instructions
1.
Install battery in “Main” headset and turn power switch “ON”.
The
blue LED will flash blue.
2.
Install battery in “Remote” UltraLite / UltraPak.
3.
Press and hold programming button (Blue LED) on “Main” headset
for five seconds. LED will begin flashing blue/red. This indicates that the
“Main” is ready to link to a “Remote” UltraLite / UltraPak.
