ASSEMBLY INSTRUCTIONS
Stainless Steel Worktable with
Adjustable Undershelf
PART #313035
EG9804 Revised 07/16
CAUTION
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE.
SAVE YOUR BOX AND ALL PACKING MATERIALS.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED
IMPROPERLY PACKED.
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2016 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-9905 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
undershelf
leg
Step 1 - While on its side, mount undershelf to legs at
desired height*. Seat one leg at a time.
• Secure legs to undershelf with set screw* (using 5/32˝ allen wrench).
• Each leg must be at the same height or shelf collars could fail.
NOTE: Undershelf must be level. Use care not to overtighten
undershelf set screws* or failure will occur. Recommended height
from the floor to the top of undershelf is 10˝.
leg
undershelf
Mark desired height
on each leg with magic
marker or grease pencil
undershelf joined with legs
Hardware:
gusset
tabletop
leg
adjustable foot
(UNDERSIDE VIEW)
Tool required:
• 5/32˝ allen wrench
undershelf
set
screw
(continued on next page)
* To be compliant with NSF guidelines,
either the supplied NSF set screw
caps must be installed over all
exposed set screws, or exposed set
screws must be filled with silicone
sealant.
NSF set screw cap
set
screw
Hardware is located in
plastic bag with brightly colored
“HARDWARE ATTACHED” tape.
NSF
set screw
cap