Product Manual DA110
EAE KNX DALI Gateway
DA110 R2.0
©
EAE Technology
www.eaetechnology.com
Page 4 / 21
1.3. Connection Example
Connection Example of DA110
1.4. Operation and Display
Power OK LED
(7)
:
OFF
: KNX bus failure.
ON
: KNX bus connected.
DALI Status LED
(8)
:
OFF
: No problem.
ON
: DALI line failure. Possible causes; mains supply failure, DALI line is short-circuit, mains
power is connected to DALI line.
Slow Blink : A DALI device fault is present. (Lamp fault, ballast fault …)
Fast Blink : Initialization is active.
Manual LED
(9)
:
Lights up when manual control is activated by pressing manual button.
Manual Button
(10)
:
Activate/Deactivate manual control. (Press the manual button for 3 seconds to
activate. Press shortly to deactivate manual control.)
Note:
KNX commands cannot operated when manual control is activated.
Test Button
(11)
:
If manual operation is activated, short press sends broadcast on/off command and
long press sends broadcast dim up/down command to DALI line. (Commands are sent in sequent.)
Programming LED and Button
(3)
:
Physical address localization.