Version 1.0
8.3 The handlebar and the stem
①
Hold the stem upright and pre-lock the upper screws of the stem.
②
Loosen the 4 screws of the front cover of the stem, then take the handlebar and put it into the stem to lock
the handlebar, pay attention to the corresponding middle position of the handlebar, and tighten the screws
at a proper angle of the handlebar.
③
Adjust the center of the handlebar to be in a straight line with the center of the front wheel. Tighten the
screws of the stem left and right with a 5# Allen key.
8.4 The seat post (with saddle)
①
Loosen the quick release and insert the saddle into the seat tube.
②
Straighten the angle of the saddle so that it is in line with the main tube of the frame, and adjust the height
to a suitable height (be careful not to exceed the handlebar safety line) and lock the quick release handle.
8.5 The pedals
①
Take out the pedals, pay attention to the left and right pedals, and the specifics are displayed according to
the signs on the pedal axis. The left pedal is equipped with the crank side, and the right pedal is equipped
with the chain side.
②
Take out the tool and use one end of a 15# open-end wrench to lock the pedal, the left pedal is locked in a
counterclockwise direction, and the right pedal is locked in a clockwise direction. Note that the pedal needs
to be locked.
11
