H700 User Manual
E-Lins Technology Co.,Limited
Tel: +86-755-29230581 E-mail: [email protected] www.e-lins.com
Aux2
for cell2 auxiliary antenna
2.4G
for 2.4GHz WiFi antenna
5G
for 5GHz WiFi antenna
GPS
for GPS antenna
2.3 Installment
H700 series should be installed and configured properly before putting in service. The
installation and configuration should be done or supervise by qualified engineer.
Notes:
Do not install H700 series or connect/disconnect its cable when it is power on.
2.4 SIM/UIM card installed
If your router has SIM/UIM card protector, please remove it, insert the sim card correctly,
and fix the protector.
If your router has no SIM/UIM card protector, please insert the sim card correctly.
Notes:
SIM/UIM card does not reach the designated position, the equipment can not find a card,
can't work normally, therefore inserted a try to check again for a
SIM Card
is stuck fast.
2.5 The installation of terminal blocks
This chapter is for version with terminal blocks only. Default, the H700 is with DB9 connector.
Please use DB9 cable to connect H700 and the equipment directly.
The following is for version with terminal blocks only:
H700 uses pluggable terminals to connect the user’s data and the power supply. Spacing:
3.81mm, 10 Pin; User data and power supply suggestion: 14~24AWG. Please refer to the
