e-Line Technology SIBELL QDVR-SBE32, User Manual

Page: 98 / 150

Alarm Management DVR User Manual
91
Alarm Management
Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of
each camera and then set up the alarm handling of each camera.
①
Click Start

Settings

Alarm

Sensor Alarm to go to the following interface.
② Select the alarm type (NO or NC) according to trigger type of the sensor.
③
Enable the sensor alarm of each camera.
④ Check the “Record”, “Snap”, “Alarm-out” and “Preset” and enable or disable the
“Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail” as required.
⑤
Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Record: check it and then the “Trigger Record” window will pop up automatically
(you can also click “Configure” button to pop up the window). Select camera on the
left side and then click
to set the camera as the trigger camera. Select trigger
camera on the right side and then click to cancel the trigger camera. Click “OK”
button to save the settings. The trigger cameras will record automatically when the
sensor alarm is triggered.
Snap: check it and then the “Trigger Snapshot” window will pop up automatically.
Configure the trigger camera in the window. The trigger cameras will snap
automatically when the sensor alarm is triggered.
Alarm-out: check it and then the “Trigger Alarm-out” window will pop up