E-FLITE Mini Ultra Stick PNP, Assembly Manual

Page: 6 / 28

Before Starting Assembly
Before beginning final assembly of your Mini Ultra Stick PNP,
remove each part from its bag for inspection. Closely inspect
the fuselage, wing panels, rudder and stabilizer for damage.
If you find any damaged or missing parts, contact the place
of purchase.
Note : For your convenience and to speed the
assembly process, the hinges have already
been installed and glued. We suggest that you
take a minute before beginning assembly of
your model to check them.
Grasp the wing and aileron at each hinge location, then
gently pull on the aileron to ensure the hinges are secure
and cannot easily be pulled away from either surface.
Use caution when gripping the wing and aileron to avoid
crushing or damaging the structure. Repeat this process for
the elevator and rudder.
If, however, you find that the hinges pull away, simply
wick thin CA into the hinge slots and re-install the hinges/
surfaces.
Optional Accessories
EFLA110 Power Meter
EFLP1080E 10x8 Electric Prop
Warning
An RC aircraft is not a toy! If misused, it can cause serious
bodily harm and damage to property. Fly only in open
areas, preferably at AMA (Academy of Model Aeronautics)
approved flying sites, following all instructions included with
your radio.
Keep loose items that can get entangled in the propeller
away from the prop, including loose clothing, or other
objects such as pencils and screwdrivers. Especially keep
your hands away from the propeller.