Radio Installation
Required Parts
• Fuselage
• Receiver
• Hook and loop material
• Micro pushrod keeper (2)
Required Tools and Adhesives
• Screwdriver, #0 Phillips
• Wire cutters
1. Plug in the servos and ESC into the receiver.
Mount the receiver to the side of the fuselage
using hook and loop material. Route the
antenna wire through the bottom of the fuselage
to the rear.
Note
: See our Mini Ultra Stick website
page for radio tips for quad flap operation
using this setup. There are also options listed
if you use a 6-channel transmitter and receiver.
However, this method will require the purchase
of a reversed servo and the use of a Y-harness
to connect your two inner location servos.
16
Summary of Contents for Mini Ultra Stick PNP
Page 1: ...Mini Ultra Stick PNP Assembly Manual...
Page 25: ...25...
