E-FLITE Mini Ultra Stick PNP, Assembly Manual

Page: 15 / 28

Quad Flap Modification (Optional)
Optional Parts (for Quad Flaps)
• Servo w/hardware (2 additional needed)
• Servo extension, 12" (2)
• Servos extension, 3" (6)
• 7-channel receiver
• 7-channel or greater transmitter
• Micro control connector (2 additional)
• 2mm x 4mm screw (2 additional)
• Micro control connector backplate (2 additional)
• 5" pushrod wire (2 additional)
• Control horn (2 additional)
Required Tools and Adhesives
• Hobby knife • Covering iron
• Thin CA
The Mini Ultra Stick PNP wing is designed with optional
quad-flaps. The ailerons have been designed with the option
of cutting in half using a hobby knife. White covering has
been supplied to cover the cut ends. Installing the servos is
similar to that of the aileron instructions above. There are
some additional changes.
Note : You must use a separate BEC or an
onboard receiver battery pack when utilizing
the quad flap option due to the higher number
of servos used in the aircraft and higher current
load. Brushless speed controls are not rated
to handle more than four servos under load.
Please consult the brushless speed control
instructions for details and how to disable the
BEC on your speed control.
Replace with a separate BEC, such as the
UBEC, available from www.koolflightsystems.
com or use a separate 4.8V receiver battery
pack.
First, you will need at least a 7-channel or greater transmitter
and receiver with servo reversing capability. Each servo
should be connected separately to the 7-channel receiver.
This will mean you should use two 12-inch servo extensions
to connect the two outer servos. You will also need two 3-
inch extensions to connect the two inner servos. We suggest
you use four additional 3-inch servo extensions that will
connect each servo to the receiver. This way, depending on
the receiver location, you will not have to disconnect wires
directly from the receiver each time you remove the wing.
15