OPERATION
2-29
April 1999
Part No. 001-9800-600
TX INHIB - Indicates that the transmitter has been
disabled by the Transmit Inhibit feature (see Section
2.8.4).
2.12.5 MENU MODE MESSAGES
The following messages are displayed in the
menu mode that is described in Section 2.6. Enabled
or yes is indicated by “ON”, and disabled or no by
“OFF”.
BACKLGT - Backlight
l
BRIGHT
l
DIM
l
OFF
BANK SEL - Bank select
l
Alpha tag of programmed banks
OPTION - Option on-off
l
ON or OFF
ROAMING - LTR-Net roaming on-off
l
ON or OFF
SCN CONT - Scan continue on-off
l
ON or OFF
SCN SAVE - Scan list save
l
ON = save, OFF = not saved
SCN TYPE - Selects type of scanning
l
SYSTEM - Both system and group
l
GROUPS - Group scanning only
l
OFF - Scanning off, switch disabled
S/G DISPL - Sys/grp display mode
l
ALPHA
l
NUMERIC
STEALTH - Stealth mode select
l
ON or OFF
TONES - Tone type select
l
SILENT - No tones sound
l
KEYS - Only the Select switch and key press
tones sound
l
ALERTS - All tones except preceding Key Beep
tones sound
l
ALL - The preceding Key Beep and Alert tones
sound
2.13 TEST MODE
2.13.1 GENERAL
This transceiver currently does not have a test
mode that can be selected to perform transceiver test-
ing. To manually control the transceiver, program
conventional channels.
2.13.2 DISPLAYING SOFTWARE REVISION
NUMBER
To display the software version number, turn
power on with the top two switches to right of display
pressed. The version number is displayed on the
bottom line as “VER x.xx” (see following illustration).
2.14 ERROR CODES
2.14.1 GENERAL
If error conditions occur during operation that
interrupt normal program execution, reset occurs
which usually restores normal operation, and informa-
tion on the error condition is stored. Up to 11 error
conditions can be stored. If more than 11 occur, the
first 10 continue to be stored and only the 11th code is
overwritten so it is always the most recent code. An
error condition can be caused by such things as a
defective memory chip or other hardware problems or
software problems.
When power is turned on after an error condition
has occurred, “
CODE xx” is briefly displayed on
the lower line in addition to the transceiver model
number on the upper line (see Section 2.4.1). The “xx”
indicates the number of the latest unread code.
To display the most recent error code, turn power
on with the top two option switches to the right of the
display pressed. The error code is indicated on the top
line and the operating software version number on the
bottom line. For example, error code “24” and soft-
ware version “2.01” are indicated as follows:
*
Error Code
Software Version No.
