OPERATION
2-12
November 2001
Part No. 001-7240-001
Table 2-1 Menu Mode and Option Switch Functions
Function
Menu Item
Option Switch
See Description in Section:
Backlight mode select
BACKLGHT
2.3.2
Bank select
BANK SEL
2.4.1
Display mode
S/G DISPL
2.3.4
Monitor mode
X
2.11.2
Roaming on-off [3]
ROAMING
2.9.4
Scan type select
SCN TYPE
2.6.1
Scan continue on-off
SCN CONT
2.6.9
Scan list save mode
SCN SAVE
2.6.7
Tone type select
TONES
2.4.12
Any Keypad Function
[2]
NOTES:
1. Functions left blank are not available.
[2] The option switches can also be programmed for any of the functions that are selectable by the keypad keys except 0-9.
For example, scanning can be turned on and off by the FCN SCAN keys and by an option switch programmed for the Scan
function (FCN does not need to be pressed when using the option switch). Programmable functions include: FCN, Scan, SYS,
RCL, GRP, CLR, Home, Phone, Dial, Page Menu, Squelch Adj., S.A/D, G.A/D, Send, Store,
, ,
,
, and Monitor.
[3] Available with LTR-Net operation only.
#
One use of the time-out timer feature is to prevent
a repeater from being kept busy for an extended period
by an accidentally keyed transmitter. It can also
prevent possible damage to the transmitter caused by
transmitting for an excessively long period.
2.4.12 TONE SELECT
If the TONES menu parameter is selectable, the
tones that sound can be selected. Otherwise, the tones
that sound are fixed by programming. The following
choices are available. Refer to Section 2.5.2 for more
information on using the menu mode.
Silent - All tones are disabled.
Keys - Only the key press tones are enabled.
Alerts - All tones except the preceding key press tones
are enabled.
All - Both the key press and alert tones are enabled.
2.5 OPTION SWITCHES AND MENU MODE
2.5.1 OPTION SWITCHES
The push-button switch on the top panel (see
Section 2.2.1) and the two switches on the side panel
immediately above and below the PTT switch (see
Section 2.2.2) are programmable. The functions which
can be controlled by these switches are basically the
functions that are selectable by the front panel keys
plus monitor mode select (see “Option Switch”
column in Table 2-1). This provides a way to “quick
select” these functions. Functions may be controlled
by both the option switch and the keypad key, and
some or all option switches can be disabled if desired.
2.5.2 MENU MODE
Introduction
The menu mode is selected by pressing FCN
MENU. Functions which can be controlled by the
menu mode are indicated in Table 2-1 by an entry in
the “Menu Items” column. More information on each
function can be found in the section indicated in this
table. Other menu mode information is as follows:
•
Programming determines which parameters are
displayed in the menu mode. Some functions can be
controlled by both an option switch and the menu
mode if desired.
•
Some functions can be set in a fixed condition by
not enabling the menu parameter or an option switch
