5
User Manual EE850 Duct Sensor
The sensor may only be utilized in accordance with the conditions defined in the technical data.
Otherwise, measurement inaccuracies will occur and equipment failures cannot be ruled out.
The steps recommended by the manufacturer for installation, inspections and maintenance work must
be observed and carried out for the safety of the user and for the functionality of the equipment.
Unauthorized product modification leads to loss of all warranty claims. This may be accomplished only
with an explicit permission of E+E Elektronik
®
!
1.2.3 Installation, Start-up and Operation
The EE850 duct sensor has been designed and produced under state of the art manufacturing
conditions, has been thoroughly tested and has left the factory after fulfilling all safety criteria. The
manufacturer has taken all actions to assure safe operation. The user has to make sure that the
equipment is positioned and installed in such a way that safe operation is not impaired. The user is
responsible for observing all applicable safety guidelines, local and international, with respect to safe
installation and operation on the device.
This manual contains information and notes of caution, which have to be followed by the user to assure
safe operation.
Mounting, electrical installation, putting into operation and maintenance may be performed by
qualified personnel only. Such staff must be authorized by the operator of the facility to carry out the
mentioned activities.
The qualified staff must have read and understood this manual and must follow the instructions
contained within.
All process and electrical connections shall be thoroughly checked by authorized staff before putting
the device into operation.
Do not put damaged products into operation and protect them from accidental commissioning. Mark
the damaged product as defective.
A faulty device may only be investigated and possibly repaired by qualified, trained and authorized
staff. If the fault cannot be fixed, the device shall be removed from the process.
Service operations other than described in this user manual may only be performed by the
manufacturer.
1.3 Environmental Aspects
Products from E+E Elektronik® are developed and designed due to consideration of the importance
of environmental protection. Therefore, disposal of the product also should not lead to pollution of the
environment.
Single-variety components must be separated before the transmitter is disposed of. The electronic
components must be collected and as electronic scrap properly disposed of.
2 Scope of Supply
EE850 sensor according ordering guide
Cable gland
Mounting seal
Mounting material
Two self-adhesive labels for configuration changes (see user guide at www.epluse.com/relabeling)
Test report according to DIN EN10204-2.2
Quick user guide
