SCOPE OF SUPPLY
•
For accurate measurement it is essential that the temperature of the probe and mainly of the sensing head is same as the
temperature of the air to measure.
•
Avoid mounting the EE150 transmitter in a way which creates temperature gradients along the probe. If possible, EE150 shall
be installed with the entire probe inside the duct. For installation with mounting flange, in case of different temperature inside
and outside the duct, the probe part outside the duct shall be thermally isolated.
•
The device and mainly the sensing head shall not be exposed to extreme mechanical stress.
•
Do not attempt to remove the filer cap, which is fixed. Avoid touching the sensing head at all times.
•
The stainless steel probe is ESD sensitive and shall be handled as such. Do not connect it to the ground potential.
CAUtiOn
USER‘S GUIDE
COnnECtiOn diAgrAm
EE150 - Humidity and Temperature Transmitter for HVAC applications
5
6
(class III)
(class III)
T-passive connection
for HT3xxx/HT6xxx
EE150-HT3xxx
EE150-HT6xxx
dimEnSiOnS / mOUnting
CABLE GLAND M16x1.5
80.8 (3.18)
56 (2.2)
63 (2.48)
55.3 (2.18)
39.5 (1.56)
ø 5 (ø 0.2)
ø 4 (ø 0.16)
ø
6
(ø
0.24)
ø 7
(ø 0.28)
42 (1.65)
28.55
(1.12)
200
(7.87
)
drilled hole for
mounting: ø>9 (ø>0.35)
Dimensions: mm (inch)
setup and adjustment interface (with EE-PCA)
setup and adjustment interface (with EE-PCA)
•
EE150 transmitter, type number according to order (for ordering guide see data sheet at www.epluse.com/EE150)
•
Cable gland M16 x 1.5
•
Mounting flange, PC, Ø 6.0mm
•
Test report according to DIN EN 10204 – 2.2
